Network Interface: - Framing: D4(SF)/ESF, AT&T 54016 or ANSI T1.403 - DS0 Assignment: user selectable - T1 Transmit Timing: Network, Secondary NI, Normal (CSU), Internal, Base DSX-1 or Base DTE
V.35 DTE Interface: - Clock Options: Normal/Inverted & Internal/External
Dial BackUp: - Accessible on base V.35 DTE Port - Requires optional V.35 "Y" cable - DBU Dialing: DTR dialing - DBU Test: Loopback to DCE, Test dialup network, Force dial backup
DSX-1 Interface: - Line Interface: DSX-1 per ANSI T1.102 - Physical Interface: RJ-48C, modular 8-pin - DSX-1 Framing: D4(SF)/ESF - DSX-1 Line Code: AMI/B8ZS - DSX-1 Line Length: 0 to 655 ft in 133 ft steps
Testing and Troubleshooting: - Local: Payload, Line, and DTE Loopback - Remote: - Payload, Line, and DTE Loopback - Fractional T1 Loopback: Per ANSI T1.403-1995, Annex B - CSU Loopback (from Carrier Network) - Test Pattern Generator and Detector: - QRSS and 511 (selectable DS0s) - All 0s and All 1s (transmit only) - Performance Monitoring: - Error Counts: ES, SES, UAS, % AS, % EFSEC, Alarms and Error Rates - Reports: NI information stored for last 24 hours (15-minute increments) - PRMS: ANSI performance report messages - Network & DSX-1 Interface Test Jacks: - Bantam Jacks: TX, RX and RXMON
Management Options and Interfaces: - Control In/Control Out Ports: - Interface: EIA-232, PC serial port, modem or SLIP connection to router - Physical Connector: RJ-45, modular 8-pin SNMP/Telnet - SLIP connection to router - MIB II, RFC1213, and 1407 compliant - ADTRAN Enterprise MIB for extended monitoring, 120e control/configuration and expansion module support - Service: SNMP, Telnet, ICMP, ARP, PING, T-Watch PRO