Logic Controls LS3000 POS Terminal

Logic Controls LS6000 Logic eNet I/O Unit A newer version of this item is available.
It is replaced by the Logic Controls LS6000 Logic eNet I/O Unit.

Reliable and rugged and configurable for zero single-point-of-failure

The LS3000 I/O units, when used with a Logic Net LM3000 control module, can replace costly PC workstations, network hubs and network software. To add more stations, simply increase the number of LS3000 modules. No special interface cards or additional hardware is required for the LS3000 module to communicate with peripheral devices. The LS3000 I/O unit was designed to meet the most demanding requirements of an industrial network. There are no disk drives, fans or mechanical parts that can easily fail. The enclosure is a heavy-duty zinc die cast case for extra ruggedness. Every module uses snap-to-lock connectors for secure connections. The LS3000 communicates with other workstations and the LM3000 control module using network communications protocols and topologies with proven reliability. It features high common-mode noise rejection network wiring. The poll/select protocol functionality avoids data collision, and the cyclic redundant checks virtually eliminate all communication errors. A zero single-point-of-failure configuration is also supported. LS3000 connections provide for a redundant data path to prevent network interruption due to a line breakage. The LS3000 has low power consumption that results in low internal temperature rise for higher mean time between failure. In addition, the units are tamper proof, with no on/off or selection switches and no adjustable devices. The LS3000 has a very compact form factor - only 1.0"h x 6.3"w x 5.1"d. Two mounting brackets enable these modules to be mounted almost anywhere - on a wall, ceiling, table top or under a counter. This enables it to be used in a wide variety of applications, despite severe space constraints.

The Logic Controls LS3000 is also known as the LogicControls LS3000

LS3000 Options
Logic Controls LS3000 (LS3000-PCD)
I/O Station (Logic Station, Communicates with LM3000 Drives Peripheral Devices - Comes with Power Brick and LogicNet Power cord)
Logic Controls LS3000 (LS3000)
I/O Station (Logic Station, Communicates with LM3000 Drives Peripheral Devices - Comes with Power Brick - Requires Power cord)
Recommended Accessories
Logic Controls (PB3000)
Switching Power supply for LM3000 LS3000 & LS6000
In Stock: Ships Same Day
$32.20
+ Add to Quote
Logic Controls (PA-120-5V)
Power supply for KB1700 Series
Ships in 1-2 Days
$26.00
+ Add to Quote
Logic Controls (CB-LN-RS232)
Cable (Serial) for the LM3008/LS3000
Ships in 1-2 Days
$20.60
+ Add to Quote